Clean the terminals of RAM

Everything is now at this stage of uncomplicated cleaning your computer from dust is completed, and we can proceed to the next step.

<iframe width=”560″ height=”315″ src=”https://www.youtube.com/embed/cCokZszRUSo” frameborder=”0″ allowfullscreen></iframe>

Step Three. Assembling the computer after cleaning the dust

Once cleaned the computer from dust, collect your clean system unit into a single unit. At the same time doing everything as during disassembly, only in reverse order. All components are connected to the system unit. Collect the following very carefully, so that everything was set into place in their slots. At the same time your hands are clean or wear gloves.
Click on the “Start” button, now the computer, and enjoy. After cleaning the sides of the system from dust finally completed.

Useful tips on how to avoid cleaning your computer from dust
And finally, some of the recommendations, following which you will have less to take over the vacuum cleaner and cleaning PC itself from the dust will not take much time and effort:

The system unit is not desirable to put the wall itself. It is enough to be 5 inches from the wall. This is necessary for proper ventilation and to prevent overheating of the CPU.
When you once again to do wet cleaning in the room, be sure to wipe of the system unit, as there is going to a lot of dust. Moreover, systematic wet cleaning for sistemnik reduces dust accumulation inside it.
Cleaning your computer from dust must be held at least once every six months.
Summing up, remember to myself that ordinary dust can cause serious disruption in the operation of the computer. She’s going inside the system that all leads to the fact that your computer starts to hang, slow down, there are various types of errors and so on. Often dust builds up even leads to a sudden shutdown.

In this article, we described how to clean your computer from dust, and what you need to do and be able to have and show what stages of cleaning itself is a computer from dust and dirt.

If you have any difficulties in order to clean your computer from dust, you can always refer to the center of computer assistance Compolife.ru. Masters of our service will make a full and professional cleaning dust your system unit and give valuable advice on how to protect your computer from future dust.

Gather dust from the PC

You should also focus on cleaning from dust and dirt coolers themselves due to the fact that most of the dust is there and going. In this case, the vacuum cleaner tube must be inserted close to the cooler, then it starts spinning, and there is sucked dust located there. Top grille stands, and we can not be afraid that cleaning dust hurt one of his blades.
ATTENTION! Be careful when you hold the phone near the vacuum system boards, because you can not keep up the phone and it will stick to the board. Of course, the motherboard components handset does not suck, but it may turn out not strong blow. Even such a blow can cause damage to the fragile board. C it should be neat. Do not hold the pipe cleaner too close.

Next, you need to clean your computer from dust chips, observing all the above mentioned precautions.

After that, proceed to the drawing, which already goes into play the most simple pencil in your arsenal. He will need you for the following: the point here is that the contacts – those portions of cards that are inserted directly into the motherboard connectors, sometimes have the properties of oxidized, resulting fee is unstable, and sometimes do not work. Such cases are not uncommon, when not working either RAM or video card. In this there is nothing wrong, we need the most carefully cleaned from dust.

Come back to the drawing. Take in the hands of a fee, and the most gentle on both sides we sketch contacts (edges) in pencil. Be sure to gently and carefully. As if you have been given for the restoration of an engraving of the famous Italian Renaissance painter. This unpretentious procedure allows you to get rid of oxide on tracks.

Then take the Eraser, and then gently and carefully erase drawn. It should not be much pressure eraser that does not remain on the rubber contacts. If you still remain – you can simply wipe it clean hands.

Copyright Brunds 2018
Tech Nerd theme designed by Siteturner